[Preview]
Mustang CDC Lightbar Installation GuideThe below installation instructions work for the following products:
• Mustang CDC Lightbars (Convertible)
Installation Instructions:
Remove back seat:
1. A spring-loaded retainer holds the lower seat cushion. The cushion is released by locating the retainer that is approximately 10 inches from the edge of the cushion on either side. Take a flat screwdriver and push in retainer release button. The seat should pop up and be released.
2. The back seat cushion is held by two 10mm screws, located on each lower corner. Remove screws and slide seat upward releasing cushion from bracket at the top
Remove Side Quarter Trim Panels:
1. Remove upper speaker grille (or dummy cover) and "T" trim between speaker opening and shoulder belt opening.
2. Remove retaining pushpin at convertible top well at the back edge of the trim panel.
3. Remove the two small pins holding rubber seal to front upper edge of trim panel.
4. Remove rocker sill covers starting at the front pulling upward working to rear.
5. Remove the two pushpins aligned vertically behind seat back.
Clean off any burs and re-install
Instructions care of Classic Design Concepts
Find more how-tos, instructions and videos at www.americanmuscle.com!
Download
